3M™ Cold Shrink Rubber Splicing Kit 5553, 5/8 kV, 500-1000 kcmil (Cu or Al)
- 3M ID 7000021419
- UPC 00054007090915
Details
Highlights
- Provides splicing on tape shield, wire shield and UniShield® cables
- This kit is suitable for use on solid dielectric cables, indoor or outdoor locations and direct-burial applications
- Insulator and jacket is made of EPDM for easy installation
- Rated for 5/8 kV applications
- IEEE Approved
3M™ Cold Shrink Shielded Splice Kit 5550 Series are for splicing 5 kV and 8 kV shielded, solid dielectric, power cables.
Meeting the requirements of IEEE 404, each 3M™ Cold Shrink Shielded Splice Kit 5550 Series kit contains all the materials (except connectors and optional ground strap) required to construct three (3) single conductor splices on Tape Shield, Wire Shield or UniShield® cables. Note: The kit can also be used to splice a shielded to a non-shielded 5/8 kV cable. Note: Cable sizes shown below are for standard insulation thickness. Final determining factor is cable insulation outside diameter
Suggested applications
- For splicing 5 kV and 8 kV shielded, solid dielectric, power cables
- For solid dielectric (XLP, EPR, HMPE) cables
- Indoor or outdoor locations
- Direct burial
Typical Properties
Resources
Legal disclaimer
UniShield® is a registered trademark of General Cable Technologies Corporation.
