3M™ Scotch-Weld™ Structural Plastic Adhesive DP8010
- 3M ID B40066528
Details
Highlights
- Creates strong bond on low surface energy (LSE) plastics such as polyolefin with minimal or no surface prep required
- Delivers non-sag formulation so adhesive stays where when applied
- Formulated to bond multi-material assemblies such as LSE plastics, thermoplastics, composites, and metals
- Medium viscosity allows controlled dispensing
- Strong adhesive can replace screws, rivets, and welding
3M™ Scotch-Weld™ Structural Plastic Adhesive DP8010NS is a non-sag, two-part acrylic adhesive specially formulated to bond many low surface energy plastics, including many grades of polypropylene, polyethylene, and thermoplastic elastomers (TPEs), without special surface preparation.
Structural bonds can be achieved without special surface treatments such as chemical etching, plasma, flame, corona treatment, or priming. Simply wipe the surfaces with isopropanol to remove mould release agents, dust, dirt, etc. 3M™ Scotch-Weld™ Structural Plastic Adhesive DP8010NS bonds metals, ceramics, and wood and most other plastics. The non-sag formula creates rigid adhesion. We also formulate this adhesive with 8 mil (0.20 mm)spacer beads for bond line spacing. Our 3M™ Scotch-Weld ™ Acrylic Adhesive DP8010NS starts with medium viscosity for controlled dispensing and spreads to sufficiently wet out the surface. The mix ratio is 10:1 and provides a 10-minute work life. The adhesive reaches handling strength in approximately 1 hour and is fully cured in 8-24 hours (at 72° F/22° C). Acrylic adhesives are two-part adhesives that provide excellent bond strength and durability. Often referred to as epoxy adhesives or epoxy glue, acrylics actually belong to a separate chemical family with their own unique characteristics. This very unique adhesive bonds LSE (Low Surface Energy) plastics without priming or other surface treatments.
Typical Properties
